FarmPhoto.com - Picture yourself farming.
T3RRA Cutta
Thread #53715 / / Total number of messages: 3 / Thread View Count: 571 / Add thread to favorites:
deere6320 53715 96 Rotary Cow Shed either
Rotary Cow Shed
Specification for Export "MAGNUM" Rotary Platforms



1.650 metre to 3 metre wide decks with 4.5mm 3CR12
(stainless steel like) chequer plate, steel or a combination
of concrete outer and steel inner.
Steel framework painted with anti rust paint underneath.
Angled bails with Jetter mounts (65nb main bail posts). All
bails and pipe work on the platform fabricated with
galvanised medium wall pipe. Angled bails assists with cow
loading, presents the udder at a better angle for cup
placement as the cow rotates towards the operator. All
minimising the time and effort required to place the cups on
the cows by the operator.
Variable speed drive.
Steel support rollers all with nylon side rollers and all
greasable.
Wall or post mounted console beside operator with
stop/start/reverse and variable speed control.
Latest Design deck ports with no rubber through the deck.
With the angled bails, the cows foot nearest the deck port
is further forward than if the cow was square on, the rubber
droppers are shorter and the claw to udder alignment is
perfect.
No tiring pulling and wearing rubberware up through a hole
in the platform top and dragging them across to the cow's
udder. This configuration minimises any sagging milk lines
and avoiding any unnecessary plugging and vacuum fluctions.
Pull cord around platform so platform can be stopped and
started from anywhere around it. Optional deck height
(normally about 880mm).
Rump rail pressure switch at cups on (stops the platform if
a cow gets caught getting on)
Kick rail under the rumpp rail all the way around the
platform which is an essential SAFETY feature.
Stainless steel skirt all around the platform and 300mm in
from the outside. This has a 200mm wide by 75mm deep drain
around the outside of it and this stops any muck / water
getting to the center, protecting rollers, milk plant etc
and minimising the area to be cleaned after milking.
3 Bail chains with hooks at each end.
2 sets of steps down to centre for access to plant, metres
etc (depending on size of platform)
The platform needs a minimum of 1200mm between the outer
edge and the closest wall.
The platforms are normally assembled on the site under our
supervision, with the assistance of local engineers.
0,0,0
Re: Rotary Cow Shed
the rotary cow shed outside
0,0,0
Re: Rotary Cow Shed
is this what you have deere? have you milked cows?
0,0,0
Loading Message List
[You must sign in to add photos or messages to this thread]
.
Please Note: FarmPhoto.com does not claim ownership of the photos posted here.
Contact individual posters for permission before using any of the photos.
0.065sec